Shenzhen maitengfei Automation Technology Co., Ltd
Specializing in the R & D, production and sales of automation equipment
National hotline：8617818343707
Product classification
Ultrasonic series
Computer desktop cutting machine cold cutting series
Computer integrated cutting machine cold cutting series
Computer large-scale cutting machine cold cutting series
Computer eagerly cutting machine
Computer cold and hot dual-purpose cutting machine
Hot-cutting cold and hot dual-purpose plus punching and cutting machine
Computer eagerly cutting round corner shaped tape cutting machine
Computer eager electronic eye tracking tape cutting machine
Computer eagerly cutting high-speed labeling machine
Desktop heat sealing bag making machine series
Large heat sealing bag making machine series
Ultrasonic non-woven fabric heat sealing bag making machine
PE vest plastic shopping bag heat sealing bag making machine
Automatic shaped rolling machine
Glove machine series
Sealing machine series
Wire Harness Series
Mask machine series
Laser cutting machine series
Paper straw machine series
Automatic packaging machine
Automatic slitting and winding machine
News Center
Contact us
Shenzhen Maitengfei Technology Co., Ltd
Contacts：Emily Hsu
Phone：8617818343707
Telephone：8617818343707
Address：Building C, youth dream workshop, dalanglangkou, Longhua District, Shenzhen
1. What is the working principle of the slicer? What is the difference between the desktop automatic slicer and the floor-standing slicer?
In simple terms, the working principle of the slicing machine is to cut the material into thin slices according to a certain ratio or width through a blade for subsequent use. The main difference between the desktop automatic slicer and the floor-standing type is the slicing ability. Because the latter has higher power, its slicing ability is stronger.
2. What is the reason for the oil leakage of the slicer? What's the reason for the uneven cut surface?
If the slicer leaks oil, there may be a problem with the oil pipe or the oil tank in the machine. At this time, check the oil tank and oil pipe to find out the real cause. If the slice is not flat, it may be caused by too fast slice speed or damage to the sleeve bearing.
3. After the slicer is sliced, there are obvious knife marks or cut marks on the material. What are the specific reasons?
Reason 1: The hardness of the cut material is too high, so that the slicing operation cannot be performed smoothly. At this time, a suitable blade should be replaced.
Reason 2: The blade in the slicer is not installed in place, or it is loose. At this time, the blade should be checked. If there is looseness, it should be tightened in time. Or, if the equipment is not cooled enough, the cooling oil should be adjusted at this time to make the cooling force appropriate to avoid the problem.
Telephone：8617818343707 EMAIL：2016971905@qq.com
Company address：Building C, youth dream workshop, dalanglangkou, Longhua District, Shenzhen
copyright：Shenzhen Maitengfei Technology Co., Ltd Yue ICP Bei No. 123456
Scan wechat
telephone
